• Batch in local or remote mode up or down from set point
• Simple touch switch programming with English statement prompts
• Low cost – High performance
• LCD display of 6 characters with 18mm digit height and white LED backlight
• Low flow alarm with batch cancel
• Programmable end of batch signal with an end of batch pulse of 0.0 to 99.9 seconds
• Background total
• Programmable delay on relay two start and pre-stop
• Batch set from front panel in programme mode or in run
• Pulse output per litre
• Automatic over run compensation in whole litres only
• DIP switch selectable input: turbine, reed switch, open collector, Namur & CMOS logic
• Sensor supply that can be adjusted from 8 to 20VDC
• Plug-in screw terminal electrical connections
• K factor 999,999 to .01 and set point 0.001 to 999,999
• 85 to 265VAC 47-63 Hz supply or factory fitted 12 to 40VDC isolated supply
• Optional clear silicon weatherproof boot to give front panel protection to IP67

The IBL Batch Controller is an 85 to 265VAC or 12-40VDC powered batch controller for liquids that incorporates a six (6) digit 18mm LCD (liquid crystal display). The instrument can be configured to batch volumes from 0.001 to 999,999 litres and K factors from 999,999 to 0.01. The instrument can batch up or down and provide the excitation power supply for the flow sensor.

The IBL can operate in local manual mode by front panel touch switches for Batch Start, Stop & resume or in remote mode as these functions are available for external control.