• Accepts all standard process signals
• User rangeable in engineering units
• Band gap reference
• Differential input
• 120 or 240VAC 47-63 Hz supply or factory fitted 12 to 24vdc isolated supply
• 3.5 digit high brightness LED display
• The DI35 has a 14.2mm digit height
• Decimal point selection
• The DI35H is supplied in a 48x96mm DIN enclosure
• Isolated power supply of 24VDC for loop powered sensors and transmitters
• Applications include the display of flow, level, pressure and speed

The DI35 Powered Process Indicators are advanced instruments which have been designed and manufactured to stringent specifications.

The instruments have been designed to accept all the standard analogue process signals. The input measurement is shown on a high contrast LED display. The DI35 incorporates an LSI CMOS 2000 count dual slope integrating analogue to digital converter which is designed to reject electrical interference that normally abounds in industrial environments. The front panel of the DI35 series are sealed to IP65 and the instrument includes screw terminal electrical connection.

specifications

INPUT DETAILS

• The instrument has a bipolar differential input and a temperature compensated Band gap reference. Full scale ranges of 20mV to 200VDC 200uA to 2Amps and 4-20mA are acceptable.
• CMRR greater than 86db.
• NMRR greater than 100db.

DISPLAYS

• A 3.5 digit high contrast light emitting diode (LED) with a wide viewing angle
• The DI35 has a digit height of 14.2mm

DECIMAL POINTS

Three (3) position user selectable by touch button programming.

ENVIRONMENTAL PARAMETERS

• 0-70 degrees Celsius
• 0-90% rh NON condensing

CONNECTION DETAILS

• Rear mount 10 way screw terminal strip
• Terminal 1:input common(-) for mA, volts, frequency
• Terminal 2:input (+) for mA and frequency
• Terminal 3:input (+) for 0-10 volt input
• Terminal 4:24VDC loop supply
• Terminal 5:not used
• Terminal 6:not used
• Terminal 7:not usedTerminal 8:VAC active supply or 24VDC (+)
• Terminal 9:VAC neutral supply or 0VDC (-)
• Terminal 10:Ground supply

INSTRUMENT POWER SUPPLY

120/240VAC 47-63 Hz or factory fitted DC to DC converter isolator from 5 to 48VDC.

TRANSDUCER POWER SUPPLY

A 24VDC at 30mA transducer power supply is incorporated in the instrument.

WEIGHT

DI35H is 450 grams.

MOUNTING DETAILS

DI35: Impact resistant panel mounting plastic enclosure of dimensions 96mm wide by 48mm high by 105mm deep with a panel cut out of 93mm wide by 45mm high.

ORDERING INFORMATION

• Model/input signal/display units/power supply
• Sample number: DI35/4-20mA/0-100.0/VAC
• All units shipped factory calibrated to 0-100.0